Conference Abstract Book
QUALITY CONTROL OF COFFEE: ASSESSMENT OF ROASTING DEGREE USING ASAP-MS A. Gliszczyńska-Świgło Department of Technology and Instrumental Analysis, Institute of Quality Science, Poznań University of Economics and Business Coffee is one of the most popular beverages worldwide. The roasting of coffee beans is crucial for obtaining good quality coffee, as it changes the chemical and physical properties of the green coffee beans. The degree of roasting of coffee beans is reflected by a change in their colour, but there is also a decrease in the content of, for example, polyphenolic antioxidants with chlorogenic acid as the dominant phenol. Companies roast their coffee beans using different techniques and parameters, so it is difficult to develop an industry standard for each roast level (light, medium or dark). The degree of roasting is determined by a dedicated spectrometer or (more often) by sensory properties (colour, coffee aroma) or described by roasting parameters (time and temperature). The aim of the present study was to use atmospheric solids analysis probe-mass spectrometry (ASAP-MS) as a tool to assess the coffee roasting process. In addition, the caffeine and phenolic acid contents of the coffee infusions were determined using HPLC. As colour is an important parameter used for quality control of roasted coffee, colour parameters were also measured in the CIE L*a*b* system. Colour differences ( E ab ) were also calculated in relation to samples roasted for the longest time at the highest temperature. Coffee bean samples (n=18) from Guatemala and Peru were obtained from a Polish company. They differed in the parameters of the roasting process, i.e. roasting time and roasting degree (defined as the percentage of maximum oven power used for roasting). The samples were ground and subjected to ASAP-MS analysis in positive polarisation mode (Radian ASAP Direct Mass Detector; Waters, Milford, MA, USA). Increasing the roasting time from 10 to 14-15 min and the oven power from 75% to 95% significantly reduced the amount of phenolic acids in the coffee and changed the colour parameters. No significant differences in caffeine content were observed. ASAP-MS combined with linear discriminant analysis (LDA) was found to discriminate ground coffee by degree of roasting. The results obtained were generally consistent with colour and polyphenol determinations. Samples roasted at 75% for 14-15 min, 80% for 14 min and 95% for 13-14 min had similar phenolic acid contents, with E ab no higher than 1.2 between the 75%/14-15 min or 80%/14 min and 95%/13-14 min samples. In the LDA model, these samples were very close to each other. The results highlight the potential of ASAP-MS to control coffee roasting. The method is rapid and requires minimal sample preparation, thus meeting the requirements of green analytical chemistry.
Made with FlippingBook
RkJQdWJsaXNoZXIy NzUyMDA=