Conference Abstract Book

STUDY ON THE MATERIAL PREPARATION FROM CUTIN–COPOLYMERISATION WITH OILS AND WAXES Athanasia Zoglopiti Department of Food Science and Technology, International Hellenic University, Thessaloniki, Greece The increasing need for the production of environmentally friendly packaging materials, within the broader framework of waste valorisation and the circular economy, has attracted the attention of the scientific community to the utilisation of agro-industrial by-products. The primary aim is the development of biodegradable materials derived from sustainable and natural sources. In the present dissertation the copolymerisation of cutin with various plant oils and natural waxes was investigated for the preparation of cutin-based membranes. Cutin, a biopolymer composed of C16 and C18 fatty acids, was isolated through alkaline hydrolysis under heating, followed by mechanical separation methods and finally was freeze-dried. Then, the membranes were prepared using the condensation polymerisation method. In some of these membranes the cutin was partially replaced with fatty substances (flax oil, palm oil, sunflower oil and beeswax) with various addition ratios tested (0, 5, 10, 20 and 30%). The membranes were subjected to tests to determine their mechanical properties, their water vapor permeability and their stability in distilled water and in organic solvents (isopropanol, acetone, ethyl acetate, diethyl ether, chloroform and hexane) based on changes in mass and dimensions. The results showed that high concentrations of additives reduced the maximum tensile strength. Although beeswax increased the property, when it was added in a higher percentage, induced the opposite effect. Elongation at break was also reduced in membranes containing fatty substances in high concentration. Sunflower oil and palm oil contributed to the increase in elongation at break, whereas the beeswax reduced it, except at low concentrations. Additionally, beeswax was the only additive whose presence led to a decrease in the permeability of water vapor. Furthermore, it was observed that hexane and distilled water did not affect the mass of the membranes. On the contrary, chloroform caused membrane swelling. Overall, the additives did not significantly improve the properties of membranes, since they are mechanically retained in the cutin matrix and at the same time their incorporation by weight reduces the amount of cutin . Finally, the membranes demonstrated limited stability when exposed to organic solvents. This study proposes an environmentally friendly approach to agricultural waste valorisation and the improvement of food quality using natural materials. Keywords: biodegradable membranes, cutin, copolymerization, sunflower oil, flax oil, palm oil, beeswax, waste valorization

RkJQdWJsaXNoZXIy NzUyMDA=